Danfoss MBS 3050
Heavy duty pressure transmitter with integrated pulse snubber
- Designed for use in demanding hydraulic / water applications
- Enclosure and wetted parts of acid resistant stainless steel (AISI
316L)
- Protected according to EU EMC directive
- Temperature compensated and laser calibrated
- Excellent protection against pressure peaks, cavitation and liquid
hammer
- Click for a
Danfoss Adobe Acrobat brochure
|
|
 |
Technical Data
|
|
Media: |
Air, gas, liquid |
|
Operating temperature: |
-40oC to 85oC |
|
Wetted parts: |
AISI 316L (DIN 17440 - 1.4404) |
|
Enclosure: |
IP65 |
|
Electrical connection: |
DIN 43650 plug Pg9 |
|
Accuracy: |
≤± 0.5% FS (typ.), ≤± 1% FS (max.) |
|
Supply voltage: |
9 to 34V d.c. |
|
Output signal: |
4 to 20mA |
|
Process connection: |
G1/4A, DIN 3852, O-ring, with integrated pulse snubber |
For further information call Ray - CSE's Danfoss Consultant on 0870
777 3205.
|
| Code No |
Weight Kg |
Pressure range pe |
Connection |
|
| 060G1153 |
0.18 |
0 to 250 bar |
G1/2" A male & G 1/4" A female |
Buy now |
MBS 3050 with integrated pulse snubber is specially suited for hydraulic
applications where cavitation, liquid hammer or pressure peaks may occur -
influences that often cause a short but extreme excess of the max. working
pressure of the transmitter. The integrated pulse snubber is in principle
design as a nozzle mounted in the passage between the measured medium and
the pressure sensitive element of the transmitter. Application -
Cavitation, liquid hammer and pressure peaks may occur in hydraulic systems
with changes in flow velocity, e.g. fast closing of a valve or pump starts
and stops. The problem can occur on the inlet and outlet side of a
pump or valve even at rather low operating pressures. Media condition -
Clogging of the nozzle may occur in liquids containing particles.
Mounting the transmitter in an upright position minimises the risk of
clogging, because the flow into the nozzle is restricted to the start-up
period when the dead volume behind the nozzle fills. The media
viscosity has only little effect on the response time. Even at
viscosities up to 100cSt, the response time will not exceed 4ms. E & OE |
Click for printer friendly version