search menu shopping_cart 0

Relays & Bases

    Refine Search

    Relays & Bases

    Relays are electromagnetic / electromechanical devices that change the state of galvanically isolated electrical contacts contained within. They are often used to interface control of high-voltage circuits with low-voltage signals. They typically plug in to Bases, which make for easier replacement should a fault occur, and require swapping out at a later date.

    Selecting the Right Relay:
    Choose a relay that suits your application… Specify the voltage, current, the number of circuits and the type of load you'll be controlling. Relays typically come in Single Pole, Two pole, Three Pole or Four Pole configurations.
            
    Connecting the Relay Base:
    Most relays are pluggable into their respective relay base which allows the base to be pre-wired prior to installation of the relay. Relay bases can either be screwed to the mounting plate or clip directly on to Top Hat (TS35) Din Rail.

    Click Here to See More

    Wiring the Control Signal:
    The control signal to the relay will energise the relay . This signal is typically low-voltage input. This could come from a microcontroller, a switch, a sensor, or any other source depending on the application.

    Power Supply:
    Ensure that the relay and its base receive the necessary power supply to function correctly. This is normally a separate circuit from the controlled load, and in many situations be 24VAC or DC, 110VAC or 230VAC as examples

    Load Connections:
    Connect the load (the device you want to control) to the relay's output terminals. The relay acts as a switch, opening or closing the circuit for the load based on the control signal. 
    Relays can switch around 5 Amps to 10 Amps Resistive loads (AC1) depending on how many contacts within the relay.

    Testing:
    Test the system to ensure that the relay responds correctly to the control signal and that the load is being controlled as expected.
    Many relays have an added feature of Mechanical override which can help with diagnostics with in the control panel.
    They may also come with LED or Flag indicators to show if the relay is engaged.

    Automation and Integration:
    For more advanced applications, you can consider integrating relays into automated systems using programmable controllers including microcontrollers (PLC’s), or sensors and timers.

    It's important to note that the specific steps and considerations may vary based on:
    -The type of relay
    -It's intended application
    -The manufacturer's guidelines. 

    Always refer to the relay datasheet and technical documentation for accurate information.

      Refine Search

      Relays & Bases